Psion Teklogix 7535 G2 Manual de usuario descargar pdf (Pagina 316)

C-44 Psion Teklogix 7535 G2 Hand-Held Computer User Manual

Appendix C: Bar Code Settings

Imager

Imager Advanced Options

Dot Time (msec)

The value selected for “Dot Time (msec)” determines (in milliseconds) how long the target-

ing dot remains on before the scanner begins capturing images. When you double-tap on this

parameter, a dialog box is displayed in which you can enter a value of between 0 and 3000.

A value of 0 disables the target dot.

C.4.2 Imager Advanced Options

Factory Defaults On Reboot

The value assigned to this parameter determines whether or not the driver will restore the

factory defaults to the imager device on the next reboot.

Min Scan Duration

This parameter defines the minimum amount of time in seconds that the imager will scan

when the trigger is pressed and held down without successful decode.

Captures Per HW Trigger

The value assigned to this parameter determines the number of captures the imager device

will take while the imager's internal hardware trigger is held down.

Important: Do not adjust the advanced options without first consulting Psion Teklogix

technical support.

Note: The driver will default the imager device on a ‘clean’ reset, regardless of the value

of this parameter.

Note: The actual scan duration when the trigger is pressed relies on the value assigned to

“Captures Per HW Trigger”, below.

Note: This parameter, together with “Min Scan Duration”, determines the actual scan

duration. When the scan trigger is pressed and held down, the driver starts a timer

based on the value of “Min Scan Duration” and also sends a command to emulate

the hardware trigger. When completed, if the time has not yet expired, it will send

another command to the imager device, forcing the imager to flash again using the

value assigned to “Captures Per HW Trigger”.

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 371 372

Sin comentarios

Psion Teklogix 7535 G2 Manual de usuario Pagina 316