Psion Teklogix 7535 G2 Manual de usuario descargar pdf (Pagina 224)

Chapter 6: Peripheral Devices & Accessories

Wiring Guidelines

194 Psion Teklogix 7535 G2 Hand-Held Computer User Manual

The most effective way to mount the picker cradle is to use the four #8-32 threaded inserts

on the rear of the unit. Bolts must not extend more than 10mm (3/8") into the cradle.

To accommodate the service loop of the connector cable, leave a 4" clearance at the bottom

of the cradle. Leave a 7" (minimum) clearance at the top of the cradle to allow easy removal

of the hand-held. Also remember to leave at least a 3" clearance at the sides of the cradle to

allow activation of the release knobs. Refer to the detailed assembly instructions that are

packaged with the cradle when selecting a mounting location.

6.11.1.1 Mounting Template

The picker cradle is shipped with detailed mounting instructions including a drill template.

6.11.2 Wiring Guidelines

Before installing the cables between the cradle and other devices, consider the following:

• Ensure that drilling holes will not damage the vehicle or its wiring.

• Protect cable runs from pinching, overheating and physical damage.

• Use grommets to protect cables that pass through metal.

• Use plastic straps and tie-downs to secure cables and connectors in their desired loca-

tion, away from areas where they may get snagged or pulled.

• Keep cables away from heat sources, grease, battery acid and other potential hazards.

• Keep cables away from control pedals and other moving parts that may damage the

cables or interfere with the operation of the vehicle.

6.11.3 Using The Picker Cradle

If your 7535 G2 is equipped with a shoulder strap or cover, these accessories need to be

removed before installing the unit in a picker cradle. There is no need to remove handstraps,

pistol grips or tethered devices from the unit.

• Slide the 7535 G2 into the cradle, and press firmly downward until it locks into place.

On a vehicle, it’s a good idea to pull up on the 7535 G2 to be certain that it is secure.

• To remove the 7535 G2, press firmly on one of the knobs on either side of the cradle

until it releases. You do not need to press both knobs.

6.11.4 Maintaining The Picker Cradle

Two latches in the cradle hold the 7535 G2 firmly in place. Although these latches are de-

signed for at least 80,000 insertion and removal cycles, they will wear over time and will no

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 371 372

Sin comentarios

Psion Teklogix 7535 G2 Manual de usuario Pagina 224