Psion Teklogix 7535 G2 Manual de usuario descargar pdf (Pagina 281)

Psion Teklogix 7535 G2 Hand-Held Computer User Manual C-9

Appendix C: Bar Code Settings

Decoded (Internal) Scanners

Decoded (Internal) Advanced Options

C.2.2 Decoded (Internal) Advanced Options

Continuous Scan Mode

Setting this parameter to on keeps the laser on and continuously decoding as long as the

scanner button is pressed and held down.

Minimum Cancel Time

The value assigned to this parameter determines the time delay before the scanner is turned

off, once the scanner trigger or button is released. This gives the scanner a minimum amount

of time to complete its current decode before the scan is cancelled when you quickly trigger

on/off.

Power Mode

This parameter is a power-saving option. Tapping on it displays a screen listing two power

mode options: Continuous Power and Low Power.

In Continuous Power mode, the scanner is always on, waiting for a trigger pull or a serial

communication.

In Low Power mode, the scanner is in a standby state, drawing minimal power until a trigger

pull or serial communication wakes it. Keep in mind that while this option is more suitable

for battery powered applications, there will be a slight delay while the scanner powers up to

scan a bar code.

Low Power Timeout

To extend laser life, you can select the time the scanner remains active following a success-

ful decode. The scanner wakes from low power mode when a bar code is scanned—a

successful decode restores normal blinking.

This is only used if the unit’s Trigger Mode has been changed to Continuous On. If the

unit is used in a fixed mount this parameter might be used, but not if the unit is used as

a hand-held.

When you double-tap on this parameter, a dialog box is displayed in which you can choose a

value of 30 sec., 1 min., 2 min. or 3 min.

Parameter Scanning

Setting this parameter to on enables decoding of parameter bar codes.

Note: This parameter is only used if the Trigger Mode has been set to Continuous On and

the 7535 G2 is mounted in a fixed position; otherwise, ‘Low Power Timeout’ is

not used.

1 2 ... 276 277 278 279 280 281 282 283 284 285 286 ... 371 372

Sin comentarios

Psion Teklogix 7535 G2 Manual de usuario Pagina 281