Psion Teklogix 9160 G2 Manual de usuario descargar pdf (Pagina 83)

Chapter 6: Managing Access Points & Clusters

Understanding Access Point Settings

Psion Teklogix 9160 G2 Wireless Gateway User Manual 59

disable (deactivate) clustered access points, and remove access points from the cluster. You

can also modify the location description for an access point. The IP address links provide a

way to navigate to configuration settings and data on an access point.

Standalone access points (those which are not members of the cluster) are not shown on this

page.

Table 6.1 describes the access point settings and information display in detail.

Table 6.1 Access Point Settings

Field Description

Location

Description of where the access point is physically located.

MAC Address

Media Access Control (

MAC

) address of the access point.

A MAC address is a permanent, unique hardware address for any device that represents an interface to the net-

work. The MAC address is assigned by the manufacturer. You cannot change the MAC address. It is provided here

for informational purposes as a unique identifier for the access point.

The address shown here is the MAC address for the bridge (

br0

). This is the address by which the AP is known

externally to other networks.

To see MAC addresses for Guest and Internal interfaces on the AP, see the Status > interfaces tab.

IP Address

Specifies the IP address for the access point. Each IP address is a link to the Administration Web pages for that

access point. You can use the links to navigate to the Administration Web pages for a specific access point. This is

useful for viewing data on a specific access point to make sure a cluster member is picking up cluster configuration

changes, to configure advanced settings on a particular access point, or to switch a standalone access point to clus-

ter mode.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 435 436

Sin comentarios

Psion Teklogix 9160 G2 Manual de usuario Pagina 83