
Psion Teklogix WORKABOUT PRO Hand-Held Computer User Manual 129
Chapter 7: Expansion Modules
Installing An SE 1223HP Scanner
• Remove the stylus and then, remove the end-cap at the top of the
WORKABOUT PRO.
• Slide the SW1401 switch to the left to shut off internal battery power.
• Remove the back plate from the unit.
A scanner flex cable is already attached to the WORKABOUT PRO. You need to
connect the flex cable to the internal scanner module.
• On the scanner module, pull the tabs on either side of the connector up.
• Using pincers, insert the flex cable into the connector on the scanner
module.
• Push the connector tabs down to secure the flex cable in place.
Figure 7.8 Attaching The Flex Cable To The Scanner Module
• Fit the scanner module over the back of the WORKABOUT PRO – it
replaces the back plate of the unit.
• Fasten the module in place with the screws provided.
Scanner
Connector
Module
Flex
Cable
Comentarios a estos manuales