Psion Teklogix netpad Manual de usuario descargar pdf (Pagina 46)

Chapter 2: Getting Started

Power Properties

Psion Teklogix netpad Windows CE .NET 4.2 User Manual

Inactivity Timer Based On Last

This parameter allows you to choose what type of event is monitored by Power

Management. If you select User Event, the Inactivity Timer for switching into

Stand-By or Suspend is started from the last time you press a Navigation button, a

function key, or use the touchscreen.

“System Events” include activity on the serial port, an active radio session, IrDA

activity, or an active application. If you select User/System Event, then the Inactiv-

ity Timer starts from the last time a User Event occurred or the last time System

activity occurred. For example, in this mode an active radio would prevent the

netpad from going into Stand-By or Suspend until after that radio session has ended.

This parameter has no impact on the Switch to Dim Inactivity Timer.

Figure 2.13 Power Schemes: Inactivity Timer based on last

Switch To Dim

During Dim state (see Figure 2.14 on page 21), the backlight brightness is turned

down after the specified time has elapsed if the netpad does not receive any user

input, including activities such as a screen tap, a scan, and so on—any user-initiated

activity. When the netpad enters the Dim state, it begins to monitor the time speci-

fied in the Switch to Stand-By menu.

Press any navigation button or tap the screen the bring the netpad out of Dim state.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 229 230

Sin comentarios

Psion Teklogix netpad Manual de usuario Pagina 46