Psion Teklogix WA1210-G2 Manual de usuario descargar pdf (Pagina 16)

Psion Teklogix WAPro Vehicle Cradle User Manual8

In the event that the Port Replicator cable is too short, Psion

Teklogix recommends the use of a standard VGA extension

cable or equivalent. Pins should be pass-through only. It is

recommended that the total cable length be kept under 3m (10’)

for best performance.

3.0 The Powered Vehicle Cradle

The Powered Vehicle Cradle is designed to allow the

WORKABOUT PRO to be powered by a vehicle battery. The

battery installed in the WORKABOUT PRO is also recharged

by the vehicle battery. This option accepts DC power sources

over the range 9V to 20V.

Warning: Applying a voltage above 20VDC or reversing

polarity may result in permanent damage to the

Vehicle Cradle power section and will void the

product warranty. For safety reasons, disconnect

the Vehicle Cradle power cable when the battery is

being charged.

3.1 Wiring Vehicle Power To The Powered Vehicle Cradle

A power cable (AMP - circular plastic connector - 2-pin) •

extends from your power Vehicle Cradle. Using a power

extension cable (Psion Teklogix Model # CA1210 - order

separately), this cradle can be wired to a ltered, fused

(maximum 5A) accessory supply on the vehicle. This ex-

tension cable is sheathed to provide added ruggedness.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sin comentarios

Psion Teklogix WA1210-G2 Manual de usuario Pagina 16